Kenwood VR-4900 Connection And Setup Manual page 4

The CHANNEL SPACE/ DE-EMPHASIS switch on the rear
panel is set to the correct setting that prevails in the area to
which the unit is shipped. However, if the CHANNEL
SPACE/ DE-EMPHASIS setting is not matched to the area
where the unit is to be used; for instance, if you move from
area 1 to area 2 as shown in the table to the right or vice
versa, desired reception of AM/ FM broadcasts is not ex-
pected. In this case, change the CHANNEL SPACE/ DE-
EMPHASIS setting in accordance with the area correspond-
ing to the table. The CHANNEL SPACE/ DE-EMPHASIS is
switched over at the same time.
• When changing the setting of the CHANNEL SPACE/
DE-EMPHASIS switch, first unplug the power cord, and
then reset the switch, plug the power cord back in, and
turn the power switch on.
iv
Unpack your new receiver carefully and make sure that all the accessories are present:
Remote control unit
Batteries
C (LR-14) × 4
(PowerTouch)
(for VR-4900/VR-4700)
AA (LR-6) × 6
(for KRF-V9993D)
ENTER
UP
CONFIRM
DOWN
CONTRAST ON/STANDBY REMOTE OFF
If any accessories are missing, or if the receiver is damaged or fails to operate, notify your dealer immediately. If your receiver was
shipped to you directly, notify your shipper immediately. Kenwood recommends that you retain the original carton and packing
materials in case you need to move or ship the receiver in the future.
CHANNEL SPACE / DE-EMPHASIS Switch
Not present for USA, Canada and Australia
Area
USA, Canada,
and South
1
American
Countries
Other
2
Countries
Unpacking
AM Loop Antenna
CHANNEL DE-
SPACE freq. EMPHASIS
FM : 100 kHz
75 µs
AM : 10 kHz
FM : 50 kHz
50 µs
AM : 9 kHz
RF remote Antenna
FM Antenna
(VR-4900/VR-4700 only)
CHANNEL SPACE
DE-EMPHASIS switch
DE-EMPHASIS
CHANNEL SPACE
50 µs 75 µs
FM 50kHz FM 100kHz
AM 9kHz
AM 10kHz
ND AM