Plug And Play; To Select The Source - Samsung LN-R238W Quick Setup Manual

BN68-00515V-00.qxd 1/11/05 4:10 PM
Plug & Play
When the TV is initially powered on, several basic customer settings proceed automatically and subsequently.

To Select the Source

Press the SOURCE button on the remote control
You can select the TV mode or an input source connected to the TV set.
Use this button to choose an input source that you would like to watch.
You can only select a source if it is connected to your TV.
Page 6
1
Press the POWER button
on the remote control.
The message
"Start Plug & Play" is
displayed with "OK" selected.
2
Select the appropriate
language by pressing the
UP/DOWN buttons.
Press the ENTER button
to confirm your choice.
3
The message
"Check Antenna Input" is
displayed with "OK" selected.
Press the ENTER button.
4
Press the UP/DOWN
buttons to select "Air", "STD",
"HRC", or "IRC", then press
the ENTER button.
5
Press the ENTER button
to select "Start".
The TV will begin memorizing
all of the available channels.
6
Press the ENTER button.
Press the LEFT/RIGHT
buttons to move to the
"Hour", "Minute" or "am/pm".
Set the "Hour", "Minute" or
"am/pm" by pressing the
UP/DOWN buttons.
Press the ENTER button.
7
The message
"Enjoy your watching."
is displayed.