Kenwood TK-280 Service Manual page 14

TK-280
8-2. Channel Setting Mode
This is a mode for making channel settings with the panel
keys without using the FPU.
Pressing [MON] when [SELF PROG] is displayed, sets
Channel Setting Mode.
Select an item set with [C] and change the selection with the
encoder.
The data displayed with [B] is stored in the memory and
then proceeds to the next item. Pressing [C] proceeds to the
next item without storing it in the memory.
Press [MON] to set the display to [SELF PROG] and return
to reset (default) status.
● Flow Chart
14
REALIGNMENT
X57-5740
Foil Side
R134
Fig. 3
Self programming mode
[MON]
[MON]
Channel set mode
[B]
[MON]
RX frequency
[LAMP]
[B]/[C]
[MON]
RX signalling
[LAMP]
[B]/[C]
[MON]
TX frequency
[LAMP]
[B]/[C]
[MON]
TX signalling
[LAMP]
[B]/[C]
[MON]
Scan delete/add
[B]/[C]
[MON]
Busy channel lockout yes/no
[B]/[C]
[MON]
RF Power High/Low
[B]/[C]
[MON]
Beat shift yes/no
[B]/[C]
[MON]
Wide/Narrow
[B]/[C]
Items set in Channel Setting Mode are as follows.
Function settings Display
Channel select CH or GRP
RX Frequency RXF
RX Signalling RXS
TX Frequency TXF
TX Signalling TXS
Scan Del/Add SCN
Busy Channel BSY
Lockout
RF Power PWR
Beat Shift SFT
Wide/Narrow W/N
Channel selection Group selection
[C]
OFF
[LAMP]
OFF QT DQT N
[LAMP] [LAMP]
OFF
[LAMP]
QT DQT N
OFF
[LAMP] [LAMP]
Remarks
[LAMP] : Freq. On/Off switching
[A] : 2.5kHz/5kHz/6.25kHz/
7.5kHz/1MHz step switching
[LAMP] : OFF/QT/DQT switching
[A] : 1 step/Standard switching
[S] : DQT Normal/Invert swtiching
Key operation same as RX
Frequencies
Key operation same as RX
Signalling
Delete/Add
YES/NO
HIGH/LOW
YES/NO
Wide/Narrow
DQT I
[S]
DQT I
[S]