Toshiba MW27FN1 Service Manual page 33

NOTE
1. After the assembly of the Rack Feed, check if the Rack
Feed 1/2 is moving smoothly. (Refer to Fig. 3-7-B)
2. In case of the Rack Feed Ass'y installation, install cor-
rectly as Fig. 3-7-C.
Moving smoothly
Moving smoothly
Check the position of
the Rack Feed Lever.
3-8: RELAY PCB ASS'Y (Refer to Fig. 3-8-A)
Remove the screw 1.
1.
2. Remove the Relay PCB Ass'y.
Relay PCB Ass'y
• Screw Torque: 4 ± 0.5kgf•cm 1
NOTE
1. When installing the wire of the Relay PCB, install it
correctly as Fig. 3-8-B.
DISASSEMBLY INSTRUCTIONS
Fig. 3-7-B
Should not be engaged.
Fig. 3-7-C
Main Chassis Ass'y
Fig. 3-8-A
Fig. 3-8-B
B3-3
3-9: GEAR (Refer to Fig. 3-9-A)
Unlock the support 1.
1.
2. Remove the Middle Gear 1/2/3, Idler Gear and Feed Gear.
Middle Gear 2
Middle Gear 3
Idler Gear
Main Chassis Ass'y
NOTE
1. In case of the Idler Gear installation, install correctly as
Fig. 3-9-B.
2. When installing the Middle Gear 2, check if the Middle
Gear 2 is locked correctly as Fig. 3-9-C.
[OK] [NG]
Idler Gear
Idler Arm
Check Lock
Middle Gear 2
3-10: IDLER ARM (Refer to Fig. 3-10-A)
1. Remove the Idler Arm Spring.
2. Remove the Chassis Spring.
3. Remove the Idler Arm.
Idler Arm Spring
Main Chassis Ass'y
Middle Gear 1
Feed Gear
Fig. 3-9-A
Idler Gear
Idler Arm
Fig. 3-9-B
Fig. 3-9-C
Idler Arm
Chassis Spring
Fig. 3-10-A