Toshiba MW27FN1 Service Manual page 27

[OK]
Tension Connect
[NG]
Tension Connect
Tension Connect
Main Chassis
2-8: T BRAKE ARM/T BRAKE BAND (Refer to Fig. 2-8-A)
1. Remove the T Brake Spring.
2. Turn the T Brake Arm clockwise and bend the hook
section to remove it.
Unlock the 2 supports 1 and remove the T Brake Band.
3.
T Brake Band
Hook section
1
1
NOTE
1. In case of the T Brake Band installation, install correctly
as Fig. 2-8-B.
[OK]
T Brake Band
[NG]
T Brake Band
2-9: S REEL/T REEL/IDLER ARM ASS'Y/IDLER GEAR
(Refer to Fig. 2-9-A)
1. Remove the S Reel and T Reel.
Remove the 2 Polyslider Washers 1.
2.
3. Remove the Idler Arm Ass'y and Idler Gear.
DISASSEMBLY INSTRUCTIONS
Tension Band
Tension Band
Fig. 2-7-D
Fig. 2-7-E
T Brake Arm
T Brake Spring
Fig. 2-8-A
T Brake Arm
T Brake Arm
Fig. 2-8-B
B2-3
NOTE
1. Take care not to damage the gears of the S Reel and T
Reel.
2. The Polyslider Washer may be remained on the back of
the reel.
3. Take care not to damage the shaft.
4. Do not touch the section "A" of S Reel and T Reel. (Use
gloves.) (Refer to Fig. 2-9-A) Do not adhere the stains
on it.
5. When you install the reel, clean the shaft and grease it.
(If you do not grease, noise may be heard in FF/REW
mode.)
6. After installing the reel, adjust the height of the reel.
(Refer to MECHANICAL ADJUSTMENT)
Idler Gear
(B)
S Reel
(A)
1
NOTE
1. In case of the S Reel and T Reel installation, check if the
correct parts are installed. (Refer to Fig. 2-9-B)
2. In case of the Idler Arm Ass'y installation, install correctly
as Fig. 2-9-C. And also set it so that the section "B" of
Fig. 2-9-A is placed under the Main Chassis tab.
Big Hole
(S Reel)
[OK]
Clutch Gear
[NG]
Clutch Gear
Idler Arm Ass'y
T Reel
(A)
1
Fig. 2-9-A
Small Hole
(T Reel) Fig. 2-9-B
Idler Arm Ass'y
Idler Arm Ass'y
Fig. 2-9-C