Cisco Small Business AP541N Administration Manual page 99

Dual-band single-radio access point
Hide thumbs Also See for Small Business AP541N:
Table of Contents

Advertisement

4
94
Table 24 QoS Parameters (Continued)
Field
Max. Burst
Wi-Fi Multimedia Settings
Wi-Fi MultiMedia
(WMM)
Description
The Max. Burst is an AP EDCA parameter and only applies
to traffic flowing from the access point to the client station.
This value specifies (in milliseconds) the maximum burst
length allowed for packet bursts on the wireless network. A
packet burst is a collection of multiple frames transmitted
without header information. The decreased overhead
results in higher throughput and better performance.
Valid values for maximum burst length are 0.0 through
999.0.
Wi-Fi MultiMedia (WMM) is enabled by default. With WMM
enabled, QoS prioritization and coordination of wireless
medium access is on. With WMM enabled, QoS settings on
the access point control downstream traffic flowing from
the access point to client station (AP EDCA parameters)
and the upstream traffic flowing from the station to the
access point (station EDCA parameters).
Disabling WMM deactivates QoS control of station EDCA
parameters on upstream traffic flowing from the station to
the access point.
If WMM disabled, all the fields below it are not able to be
edited.
To disable WMM, click Disabled.
To enable WMM, click Enabled.
Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
Configuring Quality of Service (QoS)
Wireless

Advertisement

Table of Contents
loading

Table of Contents