Cisco Small Business AP541N Administration Manual page 74

Wireless
Modifying Virtual Access Point Settings
Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
Table 16 WPA Enterprise Field Descriptions
Field Description
Select the cipher suite you want to use:
Cipher Suites
By default both TKIP and CCMP are selected. When both
TKIP and CCMP are selected, client stations configured to
use WPA with RADIUS must have one of the following:
Displays which RADIUS server is in use. You can manually
Active Server
change from this server to a different server by selecting the
desired server in the dropdown box.
NOTE:
first configured RADIUS server is selected when the device
is rebooted or reset.
By default each VAP uses the global RADIUS settings that
Use Global
RADIUS Server you define for the access point at the top of the VAP page.
Settings
However, you can configure each VAP to use a different set of
RADIUS servers.
To use the global RADIUS server settings, make sure the
check box is selected.
To use a separate RADIUS server for the VAP, clear the check
box and enter the RADIUS server IP address and key in the
fields.
Enter the address for the primary RADIUS server for this VAP.
RADIUS IP
Address
Enter up to three IPv4 addresses to use as the backup
RADIUS IP
Address 1–3 RADIUS servers for this VAP.
If authentication fails with the primary server, each
configured backup server is tried in sequence.
• TKIP
• CCMP (AES)
• TKIP and CCMP (AES)
• A valid TKIP RADIUS IP address and RADIUS Key
• A valid CCMP (AES) IP address and RADIUS Key
The Active Server is not stored across reboots. The
4
69