Cisco Small Business AP541N Administration Manual page 45

3
NOTE
40
Table 8 IEEE 802.1X Authentication Field Descriptions
Field Description
Enter the MD5 username for the access point to use when
Username
responding to requests from an 802. 1 X authentication server.
The username can be 1 to 64 characters in length. ASCII
printable characters are allowed, which includes upper and
lower case letters, numbers, and special symbols such as @
and #. Double quote (") is not a valid character.
NOTE:
field is not editable.
Enter the MD5 password for the access point to use when
Password
responding to requests from an 802. 1 X authentication server.
The password can be 1 to 64 characters in length. ASCII
printable characters are allowed, which includes upper and
lower case letters, numbers, and special symbols such as @
and #. Double quote (") is not a valid character.
NOTE:
field is not editable.
After you configure the settings on the Authentication page, you must click Apply
to apply the changes and to save the settings. Changing some settings might cause
the access point to stop and restart system processes. If this happens, wireless
clients will temporarily lose connectivity. We recommend that you change access
point settings when WLAN traffic is low.
If the 802. 1 X Supplicant is Disabled, the Username
If the 802. 1 X Supplicant is Disabled, the Password
Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
Configuring 802. 1 X Authentication
Setup