Resetting The Device By Using The Reset Button - Cisco Small Business AP541N Administration Manual

1
14
DHCP is enabled on the Cisco AP541N by default. When a DHCP server is
enabled on your network and the access point is connected to the network, the
DHCP server replaces the default static IP address with a DHCP server–assigned
IP address. If this happens before you display the Access Point Configuration
Utility window, you must use the assigned IP address to display the utility. If this
happens during configuration, the Access Point Configuration Utility will lose
connectivity.
You can query the DHCP server for the new IP address or disconnect the access
point from the network and reset the device to use the static default access point
IP address by using the
Configuration, page 114

Resetting the Device by using the Reset Button

To use the Reset button to reboot or reset the access point, do the following:
• To reboot the access point, press the
than 10 seconds.
• To restore the access point to the factory default settings:
1. Disconnect the access point from the network or disable all DHCP
servers on your network.
2. With the power on, press-and-hold the
seconds.
Resetting the Access Point to the Factory Default
procedure.
Reset
Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
Getting Started
Troubleshooting Your Connection
button. Do not hold it for more
Reset button for more than 10