Craftsman 247.770990 Operator's Manual page 8

Upper
Hose
Handle
Bracket
A
Lower
Hose
Handle
Bracket
Hose
Handle
B
Hangar
Bracket
Figure 6
Bag/Chute
Switch Button
A
Stud
Figure 7
ASSEMBLY
Hose
Bag
Clip
B
Bag
Handle
C
Strap
6. a. Snap the hose handle first into the upper hose handle bracket
and then into the lower hose handle bracket.
b. Lay hose tubing on hanger bracket next to chipper chute. See
Figure 6.
ATTACHING THE BAG
7. Grasp bag handle with one hand and slide locking rod on mounting
bracket with other hand toward engine. Use the end of mounting
bracket as leverage when sliding the locking rod.
a. Slip bag over the rim of the discharge opening and release
locking rod to secure bag in place. See Figure 7.
b. Snap bag clip to the top of the lower handle.
c. Place the lower straps on the bag over the top of lower handle,
hooking them on the studs. See Figure 7.
NOTE: The bag/chute switch button attached to the mounting bracket
must be fully depressed by the tip of front tab on bag handle when
securing the bag or engine will not start.
8