Cantilever Mounting - Single Or Double; Figure 2: Cantilever Mounting; Figure 3: Mounting Kits - Inova OnTimeTM Owner's Manual

Inova OnTime Digital Clock Owner's Manual
Cantilever Mounting – Single or Double
The following is a recommended procedure for cantilever mounting. This procedure
requires a mounting kit, Model ONTKIT.

Figure 2: Cantilever Mounting

1. Determine the clock mounting location.
2. Using the template provided, mark the location where the clock is to be mounted, making
sure the center is located over the data cable outlet.
3. Join the Ethernet Clock Mount (Inova p/n 714755) and the Ethernet Clock Cantilever Wall
Mount (Inova p/n 714756) using a #2 Phillips screwdriver and a 3/8" (.952 cm) wrench. Make
sure that the 2 washers are fitted between the Clock Mount and the Cantilever Wall Mount.
Refer to the illustration below.
Figure 3 - Mounting Kits
4. Insert 10 to 12 inches (30 cm) of data cable through the center hole of the mounting unit.
All claims based on information publicly available at time of printing. All other product or service names mentioned in this document may be
trademarks of the companies with which they are associated. © 2007 Inova Solutions. | All rights reserved. 6.12.2007 | page 6