Troubleshooting - Maytag W10368555A Use And Care Manual

TROUBLESHOOTING

First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
to possibly avoid the cost of a service call...In U.S.A. http://www.maytag.com/help – In Canada www.maytag.ca
If you experience
Vibration or Off-Balance
vibration, rocking, or
"walking"
vibration during spinning
or washer stopped with
all dial lights flashing
Noises
Clicking or metallic
noises
Gurgling or humming
Water Leaks
Check the following for
proper installation:
Washer not performing as expected
Not enough water
in washer
Possible Causes
Feet may not be in contact with the
floor and locked.
Washer may not be level.
Load could be unbalanced.
Objects caught in washer drain
system.
Washer may be draining water.
Washer not level.
Fill hoses not attached tightly.
Fill hose washers.
Drain hose connection.
Check household plumbing for leaks
or clogged sink or drain.
Washer not loaded as
recommended.
Load not completely covered
in water.
Front and rear feet must be in firm contact with floor, and washer
must be level to operate properly. Jam nuts must be tight
against the bottom of the cabinet.
Check floor for flexing or sagging. If flooring is uneven, a 3/4"
(19 mm) piece of plywood under your washer will reduce sound.
See "Level the Washer" in "Installation Instructions."
Load dry items in loose heaps evenly around basket wall.
Adding wet items to washer or adding more water to basket
could unbalance washer.
Avoid washing single items. Balance a single item such as a
rug or jeans jacket with a few extra items. If the dial is flashing,
redistribute the load, close the lid, and press START/PAUSE.
Use Bulky cycle for oversized, non-absorbent items such
as comforters or poly-filled jackets. Other items are not
appropriate for Bulky cycle. See "Cycle Guide."
Item or load not suitable for selected cycle. See "Cycle Guide"
and "Using Your Washer" in this "Use and Care Guide."
Empty pockets before washing. Loose items such as coins
could fall between basket and tub or may block pump.
It may be necessary to call for service to remove items.
It is normal to hear metal items on clothing such as metal snaps,
buckles, or zippers touch against the stainless steel basket.
It is normal to hear the pump making a continuous humming
sound with periodic gurgling or surging as final amounts of
water are removed during the spin/drain cycles.
Water may splash off basket if washer is not level.
Tighten fill-hose connection.
Make sure all four fill hose flat washers are properly seated.
Pull drain hose from washer cabinet and properly secure it to
drainpipe or laundry tub.
Do not place tape over drain opening.
Water can back up out of a clogged sink or drainpipe. Check
all household plumbing for leaks (laundry tubs, drain pipe,
water pipes, and faucets).
Unbalanced loading can cause basket to be out of alignment
and cause water to splash off tub. See "Using Your Washer"
for loading instructions.
This is normal operation for an HE low-water washer. The load
will not be completely underwater. The washer senses load sizes
and adds correct amount of water for optimal cleaning. See
"What's New under the Lid."
IMPORTANT: Do not add more water to washer. The added
water lifts the load off the impeller, resulting in less cleaning.
Solution
13