Remote Controller Overview And Operations - Fujitsu ASU9RLF1 Operating Manual

Remote Controller Overview and Operations

• To prevent malfunction or damage of the remote controller:
- Place remote controller at where will not be exposed to direct sunlight or excessive heat.
- Remove batteries if the product is not going to be used for an extended period.
- Exhausted batteries must be removed immediately, and be disposed according to the local laws and regulations of your region.
• If leaking battery fl uid comes in contact with your skin, eyes, or mouth, immediately rinse with plenty of clean water, and consult your physician.
• Obstacles such as a curtain or wall between the remote controller and the indoor unit may affect the appropriate signal transmission.
• Do not apply strong shocks to the remote controller.
• Do not pour water on the remote controller.
• Do not attempt to recharge dry batteries.
1
5 Press CLOCK ADJUST button to start clock setting.
6 Set the time by pressing SELECT button.
Each time you press the button, the value increases or
decreases 1 minute. With pressing and holding the button, the
value increasesor decreases 10 minutes.
* By pressing the TEMP. () buttons, the time indicator can be
changed from a 24-hour to a 12-hour clock.
7 Press the CLOCK ADJUST button again to complete the clock
setting.
You can quickly start the operation with following 3 steps:
1
START/STOP button
2
MODE button
Switches operation mode in following order.
AUTO COOL
Notes in HEAT mode:
• At the beginning of the operation, the indoor unit operates at very
low fan speed for about 3–5 minutes for preparation, and then
switches to the selected fan speed.
• Automatic defrosting operation overrides the heating operation when
it is necessary.
Battery (R03/LR03/AAA × 2) loading and remote controller preparation
3
2
DRY FAN HEAT
CAUTION
4
8
Press the °C / °F button to select the preferred temperature unit.
(Factory setting is °F.)
Notes:
• Use specifi ed type of battery only.
• Do not use new battery and used battery together.
• Batteries can be used about 1 year in ordinary use.
• If the remote control range noticeably got shorten, replace the
batteries, and press RESET button.
REG1U
3
SET TEMP. (temperature) buttons
Set desired temperature.
In COOL/DRY mode, the value needs to be set at lower temperature
than current room temperature, and in HEAT mode, the value needs
to be set at higher temperature than current room temperature.
Otherwise, corresponding operation mode does not start to work.
Temperature setting range
AUTO/COOL/DRY
HEAT
*:Temperature control is not available in FAN mode.
4
Remote controller display
In this section, all the possible indicators are displayed for description.
In actual operation, the display is linked with the button operation, and
only shows the necessary indicators for each setting.
AIR CONDITIONER Wall Mounted Type
5
7
64-88 °F (18-30 °C)
60-88 °F (16-30 °C)
OPERATING MANUAL
6
8
(continued)
En-3