Putting The Handset Into Service; Removing The Protective Cover; Inserting The Batteries - Siemens HiPath 500 Operating Instructions Manual

Putting the handset into service

Removing the protective cover

Remove the protective cover from the display before
putting the handset into service.

Inserting the batteries

The handset is supplied with two approved batteries. The batteries are
supplied uncharged. They are charged in the handset.
Note:
• Note: Please observe the safety notes on the back cover.
• Only use approved batteries (
• Always replace both batteries at the same time and only use
two batteries of the same type/ from the same manufacturer!
• Open the battery compartment in a dust-free environment only.
• Your telephone directory entries and all settings remain stored
even if you remove the batteries. The date and time settings
will be reset.
• Only remove the batteries if they are defective. Any unneces-
sary removal of the batteries reduces their lifespan.
Opening the battery compartment
Press down on the ridged surface and slide the cover from the battery
compartment.
Inserting the batteries
Insert the approved batteries making sure that the poles are facing the
right directions as indicated.
Closing the battery compartment
Put the cover back in place and slide it onto the battery compartment until
it engages.
Putting the handset into service
page 17).
15