Siemens HiPath 500 Operating Instructions Manual page 117

Appendix
Error
The following appears
immediately after the
Talk key is pressed:
Connect.
No dial tone available;
no calls can be made.
The following,
for example, appears:
Base 1
Outgoing and incom-
ing calls and activation/
deactivation are not
possible.
The following appears:
Time exceeded
The following appears:
Please try later
The following appears:
Currently not acces-
sible
The following appears:
Not possible
or:
Incorrect input
or:
Nothing stored
The following appears:
Not authorized
The following appears:
Not allowed
109
Possible cause
Communication sys-
tem is being used by
other users.
Handset is blocked.
Maximum input time
was exceeded.
The On-hook key was
not pressed.
The communication
system is overloaded.
Function is currently
not available.
No connection availa-
ble under the phone
number dialled.
Speed dial number not
available, appointment
entered incorrectly,
entry blocked or not
allowed, prerequisite
not fulfilled
(for example, if there is
no second partner for
toggling), number
dialled was incomplete.
Blocked function was
called.
Incorrect PIN was
entered.
Remedy
Repeat call later.
Remove the battery from
the handset and then re-
insert it. Proceed as
when loading batteries
for first time
( page 16).
Avoid long pauses
between keystrokes.
Press the On-hook key.
Wait and try again later.
Wait and try again later.
Enter the phone number
correctly or call the
attendant console.
Correct your input,
select a permitted
option, enter the phone
number in full.
Apply to the relevant ser-
vice personnel for the
COS for the blocked
function.
Enter the correct PIN.