Specifications; Ec Declaration Of Conformity - Makita SP6000 Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Max. cutting depth
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
If the tool is equipped with the special saw blade for
aluminium, the tool can be used for sawing aluminium.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Model
Blade diameter
at 90°
at 45°
at 48°
-1
)
Overall length
Net weight
Safety class
equipment
environmentally
) : 91: dB(A)
pA
) : 102 dB(A)
WA
END201-5
Vibration
The vibration
determined according to EN60745:
Work mode : cutting chipboard
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
and its
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
compatible
value depending on the ways in which the tool is
used.
ENE067-1
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
ENF002-1
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).

EC Declaration of Conformity

We Makita
ENG102-2
manufacturer declare that the following Makita
machine(s):
Designation of Machine: Plunge Cut Circular Saw
Model No./ Type: SP6000
are of series production and
Conforms to the following European Directives:
98/37/EC until 28th December 2009 and then with
2
SP6000
165 mm
56 mm
40 mm
38 mm
2,000 - 5,200
341 mm
4.4 kg
/II
Wear ear protection
total value (tri-axial
2
) : 2.5 m/s
h
2
Corporation as the
ENG214-2
vector sum)
or less
ENG901-1
ENH101-12
responsible