Miele G 7804 Operating Instructions Manual page 8

Warning and Safety instructions
~
Please follow the advice on
installation in these instructions and the
separate Installation drawing.
~
Before connecting the machine to
the mains supply, make sure the rating
on the data plate corresponds to the
voltage and frequency of the on-site
supply. Consult a qualified electrician if
in any doubt.
~
A damaged machine is dangerous.
Switch off at the mains immediately and
call the Miele Service Department or an
authorised Miele Service Dealer.
~
Installation, maintenance and
repairs should only be carried out by a
suitably qualified and competent
person in accordance with local and
national safety regulations.
Repairs and other work by unqualified
persons could be dangerous and the
manufacturer will not be held liable.
Ensure current is not supplied to the
machine until after installation,
maintenance or repair work has been
carried out.
~
If the connection cable is damaged,
it must be replaced by a Miele
approved service technician.
~
This machine should be
commissioned and then maintained by
a Miele authorised and trained service
technician or other suitably qualified
and competent approved person.
Repairs and other work by unqualified
persons could be dangerous.
8
~
The machine must be disconnected
from the mains electricity supply before
any maintenance or repair work is
carried out. Do not reconnect it until the
maintenance or repair work has been
successfully completed.
~
For safety reasons, this machine
may only be used when it has been
fully installed.
~
Never open the casing. Tampering
with electrical connections or
components and mechanical parts is
highly dangerous to the user and can
cause operational faults.
~
Faulty components must only be
replaced by genuine Miele original
parts. The manufacturer can only
guarantee the safety of the appliance
when Miele replacement parts are
used.
~
Do not connect the machine to the
mains electricity supply by a
multi-socket unit or an extension lead.
These do not guarantee the required
safety of the machine (e.g. danger of
overheating).