Re-Setting All Parameter Changes Back To The Factory Settings - Miele G 7804 Operating Instructions Manual

Programming special functions
6. Re-setting all parameter
changes back to the factory
settings.
^ Turn the programme selector to the
STOP position f.
^ Switch off the machine.
^ Press and hold 4 and 6 at the
same time, and whilst doing so
switch the machine on with I-0
button.
The current programme status "P..."
will appear in the display and the
p / 6 indicator lights up.
^ Press 3 seven times, E07 for
programming level 7 will appear in
the display.
^ Turn the programme selector to any
switch position (except STOP).
00 or PP will appear in the display.
00 = factory setting
(Electronics have not been
re-programmed).
PP = Electronics have been
re-programmed.
^ If "PP" is displayed press 4 to
change from "PP" to "00".
^ Press the 6 button. SP appears.
^ Press 6 again. All values which had
been changed have now been now
reset to the factory settings.
40
If the hardness level setting in the
water softener had been changed
this will reset to the factory setting of
340 mg/l (19 °d). This will need to be
reset to suit the hardness level in
your area.