Table of Contents
Advertisement
SAFETY CHECK-OUT
After correcting the original service problem, perform the follow-
ing safety checks before releasing the set to the customer:
Check the antenna terminals, metal trim, "metallized" knobs, screws,
and all other exposed metal parts for AC leakage. Check leakage as
described below.
LEAKAGE
The AC leakage from any exposed metal part to earth Ground and
from all exposed metal parts to any exposed metal part having a
return to chassis, must not exceed 0.5 mA (500 microampers). Leak-
age current can be measured by any one of three methods.
1. A commercial leakage tester, such as the Simpson 229 or RCA
WT-540A. Follow the manufacturers' instructions to use these
instruments.
2. A battery-operated AC milliammeter. The Data Precision 245
digital multimeter is suitable for this job.
3. Measuring the voltage drop across a resistor by means of a VOM
or battery-operated AC voltmeter. The "limit" indication is 0.75
V, so analog meters must have an accurate low-voltage scale.
The Simpson 250 and Sanwa SH-63Trd are examples of a pas-
sive VOM that is suitable. Nearly all battery operated digital
multimeters that have a 2V AC range are suitable. (See Fig. A)
To Exposed Metal
Parts on Set
0.15 µ F
Fig. A. Using an AC voltmeter to check AC leakage.
SAFETY-RELATED COMPONENT WARNING !!
COMPONENTS IDENTIFIED BY MARK ! OR DOTTED LINE
WITH MARK ! ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS
WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS
MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
ATTENTION AU COMPOSANT AYANT RAPPORT
À LA SÉCURITÉ!!
LES COMPOSANTS IDENTIFIÉS PAR UNE MARQUE ! SUR
LES DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES
PIÈCES SONT CRITIQUES POUR LA SÉCURITÉ DE
FONCTIONNEMENT. NE REMPLACER CES COMPOSANTS
QUE PAR DES PIÈCES SONY DONT LES NUMÉROS
SONT DONNÉS DANS CE MANUEL OU DANS LES
SUPPLÉMENTS PUBLIÉS PAR SONY.
2
AC
1.5k Ω
voltmeter
(0.75V)
Earth Ground
TABLE OF CONTENTS
................................................................ 3
........................................................................... 5
4-1. Circuit Boards Location ........................................................ 7
4-2. Schematic Diagram - Main L Section - ............................... 8
4-3. Printed Wiring Board - Main L Section - ............................ 9
4-4. Schematic Diagram - Main R Section - ............................. 10
4-5. Printed Wiring Board - Main R Section - .......................... 11
4-6. Schematic Diagram - Input Section - ................................ 12
4-7. Printed Wiring Board - Input Section - .............................. 13
4-8. Schematic Diagram - Power Section - ............................... 14
4-9. Printed Wiring Board - Power Section - ............................ 15
5-1. Top and Back Panel Section ................................................ 16
5-2. Front Panel Section ............................................................. 16
5-3. Heat Sink Section ................................................................ 17
5-4. Bottom Plate and Frame Section ......................................... 18
6. ELECTRICAL PARTS LIST ...................................
MODEL IDENTIFICATION
- BACK PANEL -
PARTS No.
MODEL
4-217-757-1π
US , CND
4-217-757-2π
AEP, UK, E, AUS
• Abbreviation
CND : Canadian model
AUS : Australian model
..................................... 7
19
Parts No.
Advertisement
Table of Contents
