InFocus ScreenPlay 7205 User Manual page 34

WARNINGS:
• To avoid burns, allow the projector to cool for at least 60 minutes before
you replace the lamp.
• Do not drop the lamp module. The glass may shatter and cause injury.
• Do not touch the glass lamp screen. Fingerprints can obscure projection
sharpness.
• Be extremely careful when removing the lamp module. In the unlikely
event of the lamp rupturing, discard any edible items placed in the sur-
rounding area and thoroughly clean the area along all sides of the pro-
jector. Wash hands after cleaning the area and handling the ruptured
lamp. This product has a lamp which contains a very small amount of
mercury. Dispose of it as required by local, state or
federal ordinances and regulations. For more information see
www.eiae.org.
5 Carefully remove the lamp module by grasping and lifting the metal
bail wire. Dispose of the lamp in an environmentally proper manner.
6 Install the new lamp module, making sure that it is properly seated.
7
Tighten the single screw.
8 Replace the lamp door by sliding the tabs into the tab bays and tighten-
ing the two screws.
9
Plug in the power cable, then press the Power button to turn the projec-
tor back on.
10 Reset the lamp hour timer.
Resetting the lamp timer
To reset the lamp age, simultaneously holding down the two Brightness
buttons on the projector's keypad for 10 seconds.
Using the security lock
The projector has a security lock for use with a PC Guardian Cable Lock
System. Refer to the information that came with the lock for instructions on
how to use it.
IR in
M1-DA 1
vesa
serial control
33
1
Y Y
8 trigger 1
D5
2 2
7
Pb Pb
video
trigger 2
Pr Pr
4
5
s-video
6
3
component component
security lock