Table of Contents
Advertisement
DESCRIPTION cont.
This Hammer Drill has the following features: cont.
14. Metal Gear Box and Die-Cast Aluminum Gear Housing
For durability and long life. Helps protect tool from damage
15. High Impact-Resistant Housing
Helps protect tool from damage and reduces weight
16. Permanently Lubricated 100% Ball Bearings
For smooth operation and long life
17. Impact Resistant Case
For easy carrying and convenient storage of drill and accessories
Fig. 2
Drill / Hammer
Mode Selector Switch
Auxiliary
Handle
Forward
Reverse Lever
Spindle Lock
Depth
Stop Rod
PRODUCT SPECIFICATIONS
Rating
120 Volts, 60 Hz AC
Input
8.0 Amps
Rotary Drilling
(No-load Speed)
0-2800 / min. Variable Speed
Hammer Drilling
0-44,800 / BPM
(No-load Speed)
Chuck
1/2-in. Keyed
12
OPERATION
WARNING:
!
Remember that a careless fraction of a second is sufficient to inflict serious injury.
WARNING:
!
when operating power tools. Failure to do so could result in objects being
thrown into your eyes, resulting in possible serious injury.
VARIABLE SPEED TRIGGER SWITCH (Fig. 3)
The variable speed trigger switch controls the
variable speed in either the rotary drilling or
Bubble Level
hammer drilling modes.
The drill delivers higher speed and torque with
Variable Speed
increased pressure on the trigger switch and lower
Trigger Switch
speed and torque when the pressure is decreased.
Power Lock-on
To start the hammer drill, press the trigger switch.
Button
To stop hammer drill, release the trigger switch.
Rear Handle
with Soft Grip
NOTE: You might hear a whistling or ringing noise from the trigger switch during
low speed use. Do not be concerned; this is a normal part of the switch function.
ROTARY AND HAMMER DRILLING MODE SELECTOR SWITCH (Fig. 4)
Always have the trigger switch in the OFF
Live Tool Indicator
position when operating the mode selector
switch.
10-Ft. Power Cord
To select the rotary or hammer drilling mode:
1. Press in the end of the selector lever and
rotate so the lever points to either the
rotary drilling symbol
or the hammer drilling symbol
2. When the lever is pointing to the mode you
selected, you will feel it click in on the
selection, and the drill will now operate in
(blows per minute) Impact rate
your selected mode.
NOTE: The selector switch must be in either the rotary or hammer drilling modes
at all times; there are no operable positions between the two modes.
Do not allow familiarity with tools to make you careless.
Always wear safety goggles or safety glasses with side shields
Fig. 4
.
13
Fig. 3
Advertisement
Table of Contents
