Panasonic CS-XE9DKE Service Manual page 64

CS-XE9DKE CU-XE9DKE / CS-XE12DKE CU-XE12DKE
HOW TO TAKE OUT FRONT GRILLE
Please follow the steps below to take out front grille if
necessary such as when servicing.
1. Set the vertical airflow direction louver to the horizontal
position.
2. Slide down the two caps on the front grille as shown in the
illustration below, and then remove the two mounting
screws.
3. Pull the lower section of the front grille towards you to
remove the front grille.
Caution
When reinstalling the front grille, first set the vertical
airflow direction louver to the horizontal position and
then carry out above steps 2 - 3 in the reverse order.
AUTO SWITCH OPERATION
The below operations will be performed by pressing the
"AUTO" switch.
1. AUTO OPERATION MODE
The Auto operation will be activated immediately once the
Auto Switch is pressed.
2. TEST RUN OPERATION (FOR PUMP DOWN/SERVICING
PURPOSE)
The Test Run operation will be activated if the Auto Switch
is pressed continuously for more than 5 sec. to below 10
sec.. A "pep" sound will occur at the fifth sec., in order to
identify the starting of Test Run operation.
3. HEATING TRIAL OPERATION
Press the AUTO switch continuously for more than 8 sec. to
below 11 sec. and release when a "pep pep" sound is
occurred at eight sec.. (However, a "pep" sound is occurred
at fifth sec..)
4. REMOTE CONTROLLER RECEIVING SOUND ON/OFF
The ON/OFF of Remote Controller receiving sound can be
change over by following steps:
a. Press "AUTO" Switch continuously for more than 16
sec. to below 21 sec. A :pep", "pep", "pep" sound will
occur at the sixteenth sec..
b. Press the "Check" button once to select remote control.
A "pep" sound will occur.
c. Press the "AUTO" switch once to select remote control
receiveing sound ON/OFF. A "pep" sound indicates
receiving sound ON, and a "pep" sound indicates
receiving sound OFF.
64