Curved Handle and Professional Handle Series
1. Grasp both ends of the top grille. Push the top grille straight
up; then pull straight out. Lay the top grille on a soft surface.
B
A
B
A. Top grille
B. Cabinet side trim
2. Remove the six screws attaching each cabinet side trim to
the refrigerator and remove the side trims.
3. Stand the refrigerator up by first placing the left bottom edge
of the refrigerator on the floor, standing the refrigerator
upright, and then lowering the right-hand side of the
refrigerator down to the floor.
4. Reassemble the trim and top grille after the dolly has been
removed from the refrigerator.
I n s t a l l A n t i - T i p B o a rd s
IMPORTANT:
The solid soffit must be within 1" (2.5 cm) maximum above
the refrigerator. If the solid soffit is higher than 1" (2.5 cm) or
one is not available, prevent the refrigerator from tipping
during use.
It is recommended that board(s) be installed before the
refrigerator is installed.
Board(s) must be long enough to fully cover the width of the
compressor cover.
Locate the board(s) so the bottom surface(s) of the board(s)
is(are) 84" (213 cm) from the floor.
During installation, raise the refrigerator up so there is ¹⁄₄"
(6.35 mm) maximum between the top of the refrigerator and
the bottom of the anti-tip board(s). Do not crush the
condenser cover when raising the rear leveling legs.
Page 16