Makita LXCV01 Instruction Manual page 5

ASSEMBLY
CAUTION:
Always be sure that the cleaner is switched off and
•
the battery cartridge is removed before carrying
out any work on the cleaner.
Any work with the battery cartridge being installed
•
on the cleaner may cause a personal injury or
damage to the objects around the cleaner.
Installing dust bag
2
1
3
1. Dust outlet
2. Dust bag joint
3. Pins
4. Dust bag
011113
Hold the square section of the dust bag joint and fit the
pins inside the dust bag joint to the notches in the dust
outlet of the cleaner and then insert and turn it clockwise
all the way until it stops.
011114
At this time, make sure that the fastener part on the dust
bag faces upward.
4
1. Hook
1
NOTE:
When the dust bag joint and the ring inside the
•
dust bag come off, install as follows.
(1) Align the dust bag joint with the seam of the
dust bag and install it so that its protrusion
faces upward.
011115
(2) Tighten the ring inside the dust bag firmly so
that the pins and the ring are positioned as
shown in the figure.
1
011116
Installing the shoulder strap
1
011117
Attach one end hook of the shoulder strap onto the ring
in the front of the cleaner and thrust the other end of the
strap through the band of the dust bag and then attach
the other end hook as shown in the figure.
5
1. Protrusion
1
1. Pins
2
2. Ring
1. Shoulder strap
2. Two hooks
2