Switches and Sensors
Speed Sensor Inspection
Remove the speed sensor (see Speed Sensor Removal).
Connect the speed sensor connector [A] with the battery
[B], 10 kΩ resistor [C] and hand tester [D] as shown.
Set the tester to the DC 25 V range.
Special Tool - Hand Tester: 57001-1394
Trace [A] each side of the speed sensor surface with the
Then the tester indicator should flick [B].
If the tester indicator does not flick, replace the speed
Oxygen Sensor Removal (Europe Models)
Lower Fairing (see Lower Fairing Removal in the Frame
Disconnect the oxygen sensor lead connector [A].
Remove the oxygen sensor [A].
Oxygen Sensor Installation (Europe Models)
Never drop the oxygen sensor [A], especially on a
hard surface. Such a shock to the unit can damage
it. Do not touch the sensing part [B] and filter holes
[C] of the sensor to prevent oil contact. Oil contami-
nation from hands can reduce sensor performance.
Torque - Oxygen Sensor: 44.1 N·m (4.50 kgf·m, 32.5 ft·lb)
Run the oxygen sensor lead correctly (see Cable, Wire,
and Hose Routing section in the Appendix chapter).
ELECTRICAL SYSTEM 16-69