16-20 ELECTRICAL SYSTEM
Remove the electrolyte container from the vinyl bag.
Detach the strip of caps [A] from the container and set
aside, these will be used later to seal the battery.
Do not pierce or otherwise open the sealed cells [B] of
the electrolyte container. Do not attempt to separate
Place the electrolyte container upside down with the six
sealed cells into the filler ports of the battery. Hold the
container level, push down to break the seals of all six
cells. You will see air bubbles rising into each cell as the
Do not tilt the electrolyte container
Check the electrolyte flow.
If no air bubbles [A] are coming up from the filler ports, or
if the container cells have not emptied completely, tap the
container [B] a few times.
Keep the container in place for 20 minutes or more. Don't
remove the container from the battery until it's empty, the
battery requires all the electrolyte from the container for
Removal of the container before it is completely
empty can shorten the service life of the battery. Do
not remove the electrolyte container until it is com-
pletely empty and 20 minutes have elapsed.
Gently remove the container from the battery.
Let the battery sit for 30 minutes prior to charging to allow
the electrolyte to permeate into the plates for optimum
Charging the battery immediately after filling can
shorten service life. Let the battery sit for at least 30
minutes after filling.