Remove the following from the inner tube.
Inner Guide Bushing [A]
Outer Guide Bushing [B]
Oil Seal [D]
Remove the cylinder base [A] from the bottom of the outer
Front Fork Assembly
Check the top plug O-ring and replace it with a new one.
Replace the following parts with new ones.
Retaining Ring [A]
Dust Seal [B]
Oil Seal [C]
Inner Guide Bushing [D]
Outer Guide Bushing [E]
Fork Bottom Allen Bolt Gasket [F]
Install the guide bushing on the end of the inner tube.
Insert the cylinder unit and the spring into the inner tube,
and install the cylinder base [A] onto the cylinder end [B]
that protrudes from the bottom.
Install the cylinder base starting with its stepped end.
Insert the inner tube, cylinder unit, washer, spring, and
cylinder base as a set into the outer tube.
Install the guide bushing into the outer tube.
After installing the washer, install the oil seal [A] by using
the fork oil seal driver [B].
Special Tool - Fork Oil Seal Driver, 41: 57001-1288
Install the retaining ring into the outer tube.
Install the dust seal by hand.