Apply high-temperature grease to the grease seal lips.
Fit the collars [A] on the both sides of the hub.
Insert the front axle, and tighten the axle.
Torque - Front Axle: 108 N·m (11.0 kgf·m, 80 ft·lb)
Before tightening the axle clamp bolt on the right front fork
leg, pump the front fork up and down 4 or 5 times to allow
the right front fork leg to seat on the front axle.
Put a block in front of the front wheel to stop moving.
Tighten the axle clamp bolt [A].
Torque - Front Axle Clamp Bolt: 34 N·m (3.5 kgf·m, 25 ft·lb)
Install the lower fairing (see Lower Fairing Installation in
the Frame chapter).
Install the front brake calipers (see Caliper Installation in
the Brakes chapter).
Check the front brake effectiveness (see Brake Operation
Inspection in the Periodic Maintenance chapter).
Do not attempt to drive the motorcycle until a full
brake lever is obtained by pumping the brake lever
until the pads are against the disc. The brake will
not function on the first application of the lever if
this is not done.