Install the following on the transmission case [A].
Shift Drum [B]
Shift Drum Cam [D]
Align the pin with the hole on the shift drum cam.
Apply a non-permanent locking agent to the shift drum
cam bolt and torque it.
Torque - Shift Drum Cam Bolt: 12 N·m (1.2 kgf·m, 106 in·lb)
Install the following as a set.
Drive Shaft [F]
Output Shaft [G]
Install the forks as shown.
Position the one [H] with shortest ears on the drive shaft
and place the pin in the center groove in the shift drum.
The two forks [J] on the output shaft are identical.
Install the shift rods, noting the groove position.
The rod [K] length of the output shaft side is shorter than
the rod [L] length of the drive shaft side.
Apply molybdenum disulfide oil solution to the transmis-
sion gears shown with X marks [M].
Be sure that the spacer [P] is on the output shaft.
Transmission Assy Installation
Assemble the transmission assy (see Transmission Assy
Be sure that the dowel pins [A] are in position.
Apply grease to the O-ring [B] on the oil pipe.
Install the transmission assy on the crankcase.
Tighten the transmission case bolts.
Torque - Transmission Case Bolts: 20 N·m (2.0 kgf·m, 15