Clutch (see Clutch Removal in the Clutch chapter)
Gear Positioning Lever Bolt [A]
Gear Positioning Lever [B], Spacer, Washer and Spring
External Shift Mechanism Installation
Install the gear positioning lever [A] as shown.
Fook the spring at gear positioning lever, pushing up [F]
the fook portion, as shown.
Apply a non-permanent locking agent to the gear posi-
tioning lever bolt and torque it.
Torque - Gear Positioning Lever Bolt: 12 N·m (1.2 kgf·m,
Install the shift shaft assembly.
Apply [A] molybdenum disulfide oil solution to the rub-
bing surface between the lever [B] and pawl [C] and move
them two or three times up and down to lubricate them.
Be sure that the washer [A] is on the shaft.
Be sure that the spring hook portions [B] are as shown.