7-10 ENGINE LUBRICATION SYSTEM
Oil Pan Installation
Apply grease to the O-rings on the oil pipes [A].
Install the oil pipe plate [B] so that its guide portion [C] fits
the breather pipe [D] as shown.
Apply a non-permanent locking agent to the oil pipe plate
Torque - Oil Pipe Plate Bolt [E]: 9.8 N·m (1.0 kgf·m, 87 in·lb)
If the oil pressure relief valve [F] was removed, install it.
Apply a non-permanent locking agent to the threads [G]
of the oil pressure relief valve, and tighten it.
Do not apply too much non-permanent locking
agent to the threads. This may block the oil pas-
Torque - Oil Pressure Relief Valve: 15 N·m (1.5 kgf·m, 11
Apply grease to the O-ring [A] on the oil screen [B] and
install it on the lower crankcase half as shown.
Be sure the damper [C] is on the end of the breather pipe
Replace the oil pan gasket with a new one.
When installing the oil pan, align [A] the damper [B] on
the breather pipe with the hollow [C] on the oil pan.
Torque - Oil Pan Bolts: 12 N·m (1.2 kgf·m, 106 in·lb)