Be sure to place a piece of cloth [A] around the fuel hose
Insert a minus screw driver [B] into the slit [C]on the joint
Turn [A] the driver to disconnect the joint lock [B].
Pull [C] the fuel hose joint out [D] of the outlet pipe.
When removing the fuel hose joint, do not apply
strong force to the outlet pipe on the fuel pump. The
pipe made from resin could be damaged.
Close the fuel tank cap.
Remove the fuel tank, and place it on a flat surface.
Do not apply the load to the fuel pump outlet portion [A]
especially the outlet pipe made from resin.
Fuel Tank Installation
Note the above WARNING (see Fuel Tank Removal).
Route the hoses correctly (see Cable, Wire, and Hose
Routing in the Appendix chapter).
Check that the rubber dampers [A] are on the frame and
the fuel tank.
Check that the dampers [A] are in place on the fuel tank
If the dampers are damaged or deteriorated, replace
FUEL SYSTEM (DFI) 3-101