3-96 FUEL SYSTEM (DFI)
Throttle Body Assy
Fit the accelerator cable end [A] and the decelerator cable
end [B] into the throttle pulley.
Check fuel leakage from the throttle body assy.
Fuel spilled from the carburetors is hazardous.
Apply a thin coating of grease to the throttle cable upper
Install the upper ends of the throttle cables in the grip.
Fit the projection [A] of the right switch housing into the
hole [B] of the handlebar.
Turn the throttle grip and make sure that the throttle valves
move smoothly and return by spring force.
Check the throttle grip free play (see Throttle Control Sys-
tem Inspection in the Periodic Maintenance chapter).
Operation with an incorrectly routed cable could re-
sult in an unsafe riding condition.
Throttle Grip Free Play
Throttle Body Assy Disassembly
Do not remove, disassemble or adjust the main
throttle sensor [A], subthrottle sensor [B], sub-
throttle valve actuator [C], throttle link mechanism
[D] and throttle body assy [E], because they are
adjusted or set at the manufacturer. Adjustment
of these parts could result in poor performance,
requiring replacement of the throttle body assy.
Remove the throttle body assy (see Throttle Body Assy
Never drop the throttle body assy , especially on a
hard surface. Such a shock to the body assy can