Ide Secondary Channel Master; 3.2.10 Ide Secondary Channel Slave; 3.2.11 Total Memory - Acer Power 4100 User Manual

3.2.9

IDE Secondary Channel Master

This parameter specifies the current configuration of the IDE device connected to the master
port of the secondary IDE channel. For information on how to configure the IDE devices, see
section 3.4.3.

3.2.10 IDE Secondary Channel Slave

This parameter specifies the current configuration of the IDE device connected to the slave
port of the secondary IDE channel. For information on how to configure the IDE devices, see
section 3.4.3.

3.2.11 Total Memory

This parameter specifies the total amount of onboard memory. The memory size is
automatically detected by BIOS during the POST (Power-On Self Test). If you install
additional memory, the system automatically adjusts this parameter to display the new memory
size.
1st Bank
This parameter indicates the type of DRAM installed in the DIMM 1 socket. The
None
setting indicates that there is no DRAM installed. For the location of the DIMM sockets, refer
to Figure 2-1.
2nd Bank
This parameter indicates the type of DRAM installed in the DIMM 2 socket. The
None
setting indicates that there is no DRAM installed. For the location of the DIMM sockets, refer
to Figure 2-1.
Chapter 3 - BIOS Utility 3-7