Inspect Drive Sprocket And Sprocket Nut; Drive Belt; Check Drive Belt Condition - Victory V92TC Owner's Manual

Inspect Drive Sprocket and Sprocket Nut

1. Remove the drive sprocket cover.
On some models it may be necessary to remove portions of the exhaust system to access all of the
Notice
drive sprocket cover screws (see the Victory Service Manual or an authorized Victory dealer).
2. Inspect drive sprocket and sprocket nut for wear or damage. Make sure the sprocket nut is tight.
3. If the sprocket nut is loose, remove the sprocket nut retainer screws and the retainer.
4. Remove the sprocket nut. Replace with a new sprocket nut if necessary.
5. Clean the output shaft threads and the sprocket nut threads.
6. Apply a few drops of Loctite Thread Locker #262 or equivalent to the output shaft threads.
7. Apply the rear brake and tighten the drive sprocket nut.
Torque: 100 ft- -lbs (136 Nm)
8. Install the nut retainer and the retainer screws.
Torque: 115 in- -lbs (13 Nm)
The nut retainer can be installed in many positions and on either side. If you cannot align the mount-
Notice
ing holes, tighten the sprocket nut slightly and install the nut retainer.
9. Check rear wheel alignment (see page 80) and drive belt tension (see page 78).

Drive Belt

Check Drive Belt Condition

Replace the drive belt if it is cracked or has broken teeth or frayed edges. No matter its condition, the drive
belt should be replaced at periodic intervals (see the Victory Service Manual or an authorized Victory dealer).
Maintenance
77