HORIZONTAL STEAM IRONING
Fill water reservoir to
2. Turn the fabric select dial to select desired setting.
3. Set the variable steam selector to desired amount of steam
4. When finished ironing, turn the fabric-select dial to the Lowest setting
the variable steam selector is set to
and unplug the iron.
Stand the iron on its heel rest and allow it to cool
Use to remove wrinkles or creases from hanging garments or drapes.
Turn the fabric-select dial to select desired setting for the fabri
to be ironed
Hold iron close to, but not touching fabric
Pull fabric taut with your free hand and press the steam button as you move the
iron over the fabric.
Important: Do not bring iron too close to hand holding fabric to avoid heat.
4. For best performance, Leave an interval of 5 seconds between bursts
Be sure the water tank is filled.
1. Press the spray button to generate a spray of
On first use, pump the spray button several
Important: Do not spray silk.
Set the variable steam selector to~
2. Turn the fabric-select dial to appropriate setting for your fabric
When finished ironing, make sure to unplug the iron
Important: Always stand the iron on its heel rest when powered on or not in use.
Care and Cleaning
This product conta ins no user
Refer service to qualifi ed
Make sure iron is unplugged and has cooled completely. Wipe the
and outer surfaces with a soft cloth dampened with water and mild household
detergent. Never use abrasives, heavy-duty cleansers
vinegar or scouring pads
that may scratch or discolor th
After cleaning, steam iron over an old cloth to remove any residue from the
AUTO CLEAN® SYSTEM
To keep the steam vents free of any buildup, follow these instructions about once a
1. Fill the water tank well below MAX Line. Plug in the iron
Select fabric setting 6 on the fabric-select dial and stand the iron on its
Wait 2 minutes for the iron to heat fully, then unplug the iron.
Hold iron over a sink with the sole plate facing down
Press the Auto Clean
Important: Be careful, as after several seconds, hot water and steam will come
out of the steam vents.
Continue to hold Auto Clean
button until all the water has emptied
necessary, move iron side-to-side and
When finished, release the button
stand the iron on its heel rest and plug
Heat for about 2 minutes to dry out any remaining water.
STORING YOUR IRON
Unplug the iron and Let it cool completely.
Check that the fabric-select dial is set
Store iron on its heel rest.