Fault Codes - GE GeoSpring GEH50DEEDXX Owner's Manual & Installation Instructions

Fault codes.

fault Code
Displayed Condition
f-A T4 Not Rising
f-b Discharge Temp Not Stable
f-C Evaporator Not Frost Free
f-D Superheat Too Low
f-E Discharge Temperature Above Limit
f-f Electronic Expansion Valve Out of Range
f2 T2 Tank Temperature Sensor Failure
f-3 Compressor Failure
f-4 Fan Failure
f-5 T3a Sensor (Evap inlet temperature) Failure
f-6 T3b Sensor (Evap outlet temperature) Failure
f-7 T4 Sensor (Compressor outlet) Failure
f-8 T5 Sensor (ambient temperature) Failure
f-9 Lower Heating Element Failure
f-10 Upper Heating Element Failure
f-11 Dry Tank Fault
f13 Stuck Key Fault
f15 DataFlash Fault
bAd linE The voltage is too low at power-up
Note: If your unit shows "PS" on the display when trying to adjust the temperature, this is not a
fault code. "PS" indicates that the unit is operating with the ACM module and is in Power Saver
mode. See page 10 for details.
Action
Call service
Call service
Call service
Call service
Call service
Call service
Call service
Call service
Call service
Call service
Call service
Call service
Call service
Call service
Call service
See page 16
Call service
Call service
See page 16
GEAppliances.com
21