Download Print this page

AEG DVD 4543 HDMI Instruction Manual page 59

Dvd player
Hide thumbs

Advertisement

Table of Contents
Audio setup
Video setup
Speaker setup
05-DVD 4543_AEG_GB.indd 59
Audio output
Here you specify the settings for the digital Audio output.
OFF: Output of an analogue Audio signal, but no digital signal.
RAW: Output of a digital Audio signal. Use this setting if your ampli-
fier is notwo-channel stereo amplifier.
PCM: Output of a digital Audio signal that is converted to a 2-chan-
nel signal. Use this setting if your amplifier is a two-channel stereo
amplifier.
NOTE:
If there is no Audio output, even though you connected the DVD-
Player to an amplifier, you will most likely have chosen an incorrect
setting for the Audio output.
Key
Here you can set the speed of the sound.
Here you can make various settings to adapt the video signal.
All settings can be made with a slide control.
Brightness
Contrast
Hue
Saturation
Sharpness
Downmix
Change the characteristics of the speaker output:
LT/RT: Choose this setting if you want to play the DVD with the Pro Logic
Dolby stereo effect. This produces a almost real 2-channel replay effect.
Stereo: Choose this setting if you want to play a DVD, that has been
produced in the 5.1-Audio format, as 2-channel stereo sound.
VSS: You may probably not have a 5.1-Audio system. In this case you
can use the "VSS"-setting to simulate a similar sound effect.
5.1 CH: Select this setting to transmit the Audio signal to the output
device without changes.
NOTE:
The "SUBWOOFER", "CENTER", "CENTER DELAY", "REAR" and "REAR
DELAY" menus only appear if the "5.1CH" option is enabled on the
"DOWNMIX" menu.
Subwoofer, Center, Rear
Here you can set the characteristics of the loudspeakers.
ON: The loudspeaker emits audio signals.
Large: The loudspeaker produces bass and treble sounds.
English
59
25.09.2009 9:00:49 Uhr

Advertisement

Chapters

Table of Contents
loading