7. push the junction box below the opening.
8. remove the two T-20 Torx screws from the top
of the rear shroud cover.
9. remove the four T-20 Torx screws from the
bottom of the rear shroud cover.
10. Lift the rear shroud cover from the rear shroud.
To remove the rear shroud:
Note: The rear shroud is attached to the top of
the tank with 4 screws and 3 tabs, and to the rear
shroud cover with 4 screws.
1. remove the front shroud. (See To remove the
front shroud, this section.)
Junction Box
2. remove the two T-20 Torx screws from each
front bottom corner.
3. remove the four T-20 Torx screws from the top
of the rear shroud.
4. pull the bottom of the rear shroud out, then
remove it from the water heater.
– 41 –
Tab
Tab
Tab
(Continued Next page)