Five-Thread Or Double Chain Stitch Sewing - Husqvarna HUSKYLOCK 1002 Handbook

Five-thread or double chain stitch sewing <5-thread model only>
3.
terial.
1. When carrying out five-thread or double chain stitch sewing, first
thread the threads, and then use scissors to trim a short section.
Then place the trimmed edge against the upper cutter so that the
needle begins sewing in the edge of the material.
2. rum
the handwheel gently two or three times to check that the
threads are running smoothly, and then slowly start sewing.
When you have sewn to the edge of the material, keep sewing at
low speed to sew past the edge of the material (Chaining-off>.
Pull the chaining-off stitch away in a diagonal direction.
Cut off the extra thread about 5 cm (2 in.) from the edge of the ma
presser foot.
4.
When
continuing on to sew another piece of material, sew the next
piece without raising the presser foot.
When sewing a chaining-off stitch, it is not necessary to ruse the
If the thread becomes tangled in the double chain looper, the
double
chain stitches will not be sewn properly. If these stitches are
not being sewn properly, check the double chain looper. If
it
is tan
gled with thread, remove the tangled thread, thread the thread again
and then re-sew.
-
30
-