Trouble Shooting - Haier AS12SH1ERA Operation Manual

Split type room air conditioner
Hide thumbs Also See for AS12SH1ERA:
Table of Contents

Advertisement

Available languages

Available languages

Trouble shooting

Before asking for service, check the following
first.
Phenomenon
The system
does not restart
immediately.
Noise is heard
Normal
Performance
inspection
Smells are
generated.
Mist or steam are
blown out.
In dry mode, fan
speed can't be
changed.
Poor cooling
Multiple
check
EUROPEAN REGUL ATIONS
CONFORMITY FOR THE MODELS
CE
All the products are in conformity with the following
European provision:
- Low Voltage Directive 73/23/EEC
- Low Voltage Directive 2006/95/EC
-Electomagnetic CompatibilitY 89/336/EEC
-Electomagnetic CompatibilitY 2004/108/EC
ROHS
The products are fulfilled with the requirements in the directive 2002/95/EEC
of the European parliament and of council on the Restriction of the use of
Certain Hazardous Substances in Electrical and Electronic Equipment (EU
RoHS Directive)
Cause or check points
When unit is stopped, it won't restart
immediately until 3 minutes have
elapsed to protect the system.
When the electric plug is pulled out
and reinserted, the protection circuit
will work for 3 minutes to protect the
air conditioner.
During unit operation or at stop,
a swishing or gurgling noise may
be heard.At first 2-3 minutes after
unit start, this noise is more noticeable.
(This noise is generated by
refrigerant flowing in the system.)
During unit operation, a cracking
noise may be heard.This noise is
generated by the casing expanding
or shrinking because of
temperature changes.
Should there be a big noise from
air flow in unit operation, air
filter may be too dirty.
This is because the system
circulates smells from the interior
air such as the smell of furniture,
paint, cigarettes.
During COOL or DRY operation,
indoor unit may blow out mist.
This is due to the sudden cooling
of indoor air.
In DRY mode, when room temperature
becomes lower than temp.
o
setting+2
C,unit will run
intermittently at LOW speed
regardless of FAN setting.
Is power plug inserted?
Is there a power failure?
Is fuse blownout?
Is the air filter dirty?
Normally it should be cleaned
every 15 days.
Are there any obstacles before
inlet and outlet?
Is temperature set correctly?
Are there some doors or
windows left open?
Is there any direct sunlight
through the window during the
cooling operation?(Use curtain)
Are there too much heat sources
or too many people in the room
during cooling operation?
Cautions
Do not obstruct or cover the ventilation
conditoner.Do not put fingers
inlet/outlet and swing louver.
Do not allow children to play with the air conditioner
case should children be allowed to sit on the outdoor unit.
Specifications
The refrigerating circuit is leak-proof.
The machine is adaptive in following situation
1.Applicable ambient temperature range:
Maximum:D.B/W.B
Indoor
Minimum:D.B/W.B
Cooling
Maximum:D.B/W.B
Outdoor
Minimum:
Maximum:D.B
Indoor
Minimum:
Heating
Maximum:D.B/W.B
Outdoor
Minimum:D.B/W.B
Maximum:D.B/W.B
Outdoor
Minimum:D.B
(INVERTER)
2. If the power supply cord is damaged, it must be replaced
manufacturer
or its service agent or a similar
3. If the fuse of indoor unit on PC board is
it with the type of T. 3.15A/ 250V
broken,change it with the type of T.25A/250V
4. The wiring method should be in line with the local wiring
5. After installation, the power plug should be easily reached.
6. The waste battery should be disposed properly.
7. The appliance is not intended for use
persons without supervision.
8. Young children should be supervised
with the appliance.
9. Please employ the proper power plug,
cord.
10. A breaker should be incorporated into
should be
all-pole switch and the distance
contacts should be not less than 3mm.
11 .The power plug and connecting cable
attestation.
12.In order to protect the units,please turn
30 seconds later, cutting off the power.
13.Please don't insert any sensor on 3-way stop valve pipe
WEEE
In accordance with the directive 2002/96/CE of the European parliament,
herewith we inform the consumer about the disposal requirements of the
electrical and electronic products.
DISPOSAL REQUIREMENTS:
Your air conditioning product is marked with this symbol.This
means that electrical and electronic products shall not be mixed
with unsorted household waste. Do not try to dismantle the
system yourself : the dismantling of the air conditioning system,
treatment of the refrigerant, of oil and of other part must be done by a
qualified installer in accordance with relevant local and national legislation.
Air conditioners must be treated at a specialized treatment facility for reuse,
recycling and recovery. By ensuring this product is disposed of correctly,
you will help to prevent potential negative consequences for the
environment and humen health. Please contact the installer or local
authority for more information. Battery must be removed from the remote
controller and disposed of separately in accordance with relevant local and
nationl legislation.
grille of the air
or any other things into the
.In no
o
o
32
C/23
C
o
o
21
C/15
C
o
o
43
C/26
C
o
D.B
18
C
o
27
C
o
D.B
0
C
o
o
24
C/18
C
o
o
7 -
C/-8
C
o
o
24
C/18
C
o
-15
C
by the
qualified person.
change
broken,please
. If the fuse of
outdoor
unit is
standard.
by young children or
infirm
to ensure that they
do not play
which fit into the
power supply
fixed wiring. The
breaker
between its two
must have
acquired the local
off the A/C first,
and at least
fitting.
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents