English
Installing
1.
Make sure the blade tension knob (1) turned
counterclockwise until it stops.
2.
Remove old blade as explained in “Removing”.
3.
Guide the new blade teeth are pointing forward and
down.
NOTE: To avoiding lifting the workpiece, the blade
teeth must point downward toward the table.
4.
Swinging the left side off the blade away and back,
place the blade on the upper and lower wheels (10).
5.
Place the blade carefully between the upper and lower
blade guides (8).
6.
Slide the blade into the slot (9) at the left of the
wheels, and make sure the blade is positioned at the
middle of the wheels.
7.
Turning the blade tension knob (1) clockwise, tighten
the tension until the blade is tight on the wheels.
8.
Replace the table insert (2) and the table aligning pin (3).
Install the extension table and fasten the screw (13) at
the right of extension tube. Lock the lock knobs (12)
under the table.
9.
Adjust the blade tracking and tension properly (See
ADJUSTMENT INSTRUCTIONS section) before
operation the band saw.
WARNING
To avoid injury, the blade tension, tracking, and upper and
lower guides and bearings must be properly adjusted
before operating the band saw. (See ADJUSTMENT
INSTRUCTIONS section)
MITER GAUGE (Fig. H)
A miter gauge (1) is supplied with your band saw to be
used in the table slot (2) on the right side of the blade. The
miter gauge can be tilted 0° to 45° right or left to maintain
an accurate angle for your workpiece. A bracket is
provided on the leg stand for convenient miter gauge
storage.
Fig. H
1
2
Page 13