Right Handlebar Switches - Victory Cross Roads Owner's Manual

Instruments, Features and Controls

Right Handlebar Switches

Engine Stop/Run Switch
The engine stop/run switch is located on the right handlebar.
This switch completes or interrupts the ignition, starter and fuel
pump circuits. Use the engine stop/run switch to turn the engine
off quickly. Turn the key off after the engine stops.
• Press the bottom of the switch (RUN) to complete the circuits
and allow the engine to start and run.
• Press the top of the switch (STOP) to interrupt the circuits and
stop the engine. The engine should not start or run when the
switch is in the STOP position.
Cruise Control Switches (if equipped)
Refer to the Cruise Control section of this manual (beginning on
page 49) for cruise control operation.
Engine Starter Switch
The starter switch is located on the right handlebar. Use the
starter switch to start the engine and operate in reverse (if
equipped). The switch will operate only when the engine stop/
run switch is in the RUN position and the transmission is in neu-
tral (or the clutch is disengaged). The reverse lever (if equipped)
must also be disengaged.
Tip: If the reverse system fuse has blown, the starter switch will not
function even if the reverse lever is disengaged. Replace the fuse.
See page 84.
Read the engine starting procedures before starting the engine.
See page 46.
• Press the right side of the starter switch to engage the starter motor.
• See page 52 for reverse operation.
30
Run
Stop
Cruise Control Switches
Starter Switch