Indicator Lamps - Victory Cross Roads Owner's Manual

Instrument Cluster (CROSS COUNTRY)

Indicator Lamps

Cruise Control
Check Engine
Lamp Indicates
Neutral
High Beam
Check Engine
Turn Signal
Low Oil
Pressure
Low Fuel
Low Battery
Warning
Cruise Control
Engaged
Anti-Lock Brake
System Not
Activated
(if equipped)
Instruments, Features and Controls
High Beam
Brake System
Left Turn
Neutral
This lamp illuminates when the transmission is in neutral and the ignition
key is in the ON or PARK position.
This lamp illuminates when the headlamp switch is set to high beam.
This lamp illuminates momentarily when the ignition switch is in the ON
position and the engine is off. This indicates proper function. If this lamp
illuminates while the engine is running, contact an authorized VICTORY
dealer promptly for diagnosis. The light will remain on if the tilt sensor
shuts down the engine. See page 34. If abnormal sensor or engine
operation is detected the light will remain on as long as the fault
condition exists. Retrieve the error codes for diagnosis. See page 26.
This lamp is also known as a malfunction indicator lamp (MIL).
One arrow flashes when the corresponding turn signal is activated. Both
arrows flash when the hazard signal is activated. If a bulb fails, or if there
is a short circuit in the signal system, the lamp flashes at more than
twice the normal rate.
This lamp illuminates when the ignition switch is in the ON position and
the engine is off, indicating that the indicator circuit is functioning
properly. This lamp also illuminates if engine oil pressure drops below
safe operating pressure. If this lamp illuminates while the engine is
running, turn the engine off as soon as safely possible and check the oil
level. If the oil level is correct and the lamp remains on after the engine is
restarted, turn the engine off immediately.
This lamp illuminates when approximately one gallon (3.8 liters) of fuel
remains in the fuel tank.
This lamp illuminates when battery voltage is low. Make sure the
charging system is operating properly. See page 88.
Before using the cruise control, read the safety and operation
procedures beginning on page 49.
The ABS indicator always illuminates when the key is in the ON position
and remains on until the anti-lock system activates, which occurs when
vehicle speed exceeds 6 MPH (10 km/h). When the lamp is illuminated,
the anti-lock brakes will not activate, but the conventional brake system
will continue to operate normally.
Anti-Lock
Low Fuel
(ABS)
Battery Warning
Condition
Right Turn
Oil Pressure
25