GE GSM1800 Owner's Manual page 14

Care and cleaning.
Main filter
Cup
Fine
filter
Retaining
nut
Washer
Air gap
Check the air gap any
time your dishwasher
isn't draining well.
14
Cleaning the Filters
Inspect and clean the filters periodically. This should
be done every month. If there is a decrease in
wash performance or dishes feel gritty, this is
also an indication the filters need to be cleaned.
To clean the filters, remove the bottom rack.
Lift out the main filter and cup assembly. Lift
out the fine filter.
Cleaning the Spray Arms
Because hard water chemicals will clog the spray
arm jets and bearings, it is necessary to clean the
spray arms regularly. To remove the spray arm,
twist the retaining nut 90 degrees and pull the
spray arm off the shaft.
Protect Against Freezing
If your dishwasher is left in an unheated place
during the winter, ask a service technician to:
1 Turn off electrical power to the dishwasher.
Remove fuses or trip circuit breaker.
Turn off the water supply and disconnect the
2
water inlet line from the water valve.
Does Your Dishwasher Have an Air Gap?
An air gap protects your dishwasher against water
backing up into it if a drain clogs. The air gap is not
a part of the dishwasher. It is not covered by your
warranty. Not all plumbing codes require air gaps,
so you may not have one.
Rinse the main filter, fine filter and cup with
warm soapy water. Scouring pads or brushes
can scratch the filter surface but a soft brush
or sponge may be needed to remove stubborn
soils or calcium deposits caused by hard water.
Once cleaned replace the fine filter followed
by the cup and main filter assembly. Be sure to
press them in place as improper replacement
of the filter may reduce the performance level
of the appliance.
Wash the arms in soapy, warm water and use a
soft brush to clean the jets. Replace them after
rinsing thoroughly.
Upper rack
3 Drain water from the water inlet line and
water valve. (Use a pan to catch the water.)
Reconnect the water inlet line to the water
4
valve.
The air gap is easy to clean.
1
Turn off the dishwasher and lift off the air gap
cover.
Remove the plastic cap under the cover and
2
clean with a toothpick.
3 Replace the cap and cover when the air gap is
clean.
GEAppliances.com
Retaining nut