Impex PLATINUM MARCY PM-3000 Owner's Manual page 14

STEP 5 (See Diagram 5 & Cable Loop Diagram)
A.) Attach the 149" Upper Cable (#21) to the front opening on the Upper Frame (#4).
NOTE: The Ball Stopper on the Cable needs to be underneath the Frame.
B.) Attach a Pulley (#24) to the opening. Secure it with one M10 x 2 ½" Allen Bolt
(#50), two Ø 7/8" x 5/8" Bushings (#36), and one M10 Aircraft Nut (#62).
C.) Draw the Cable towards the back of the machine to another opening on the Upper
Frame. Repeat Procedure B above to install a Pulley.
D.) Draw the Cable around the Pulley then pull back to the upper opening on the Front
Press (#6).
E.) Attach a Pulley to the opening. Secure it with one M10 x 6 ¾" Allen Bolt (#49), two
Ø ¾" Washers (#60), and one M10 Aircraft Nut (#62).
F.) Draw the Cable around the Pulley then to the upper opening on the Vertical Frame
(#3).
G.) Attach a Pulley to the opening. Secure it with one M10 x 2 3/8" Allen Bolt (#51),
two 7/8" x ½" Bushings (#37), and one M10 Aircraft Nut (#62).
H.) Draw the Cable around the Pulley, then towards back to the lower opening on
Front Press. Repeat Procedure E to install a Pulley.
I.) Draw the Cable around the Pulley, then toward to the lower opening on Vertical
Frame.
J.) Repeat the Procedure G to install a Pulley.
K.) Draw the Cable over the Pulley and pull the Cable downwards. Attach a Pulley to
the upper holes on the two Double Floating Pulley Brackets (#14).
L.) Attach a Pulley to the Brackets. Secure it with one M10 x 1 ¾" (#52), two Ø ¾"
Washers (#60), and one M10 Aircraft Nut (#62). Let the Bracket hanging for now.
M.) Draw the Cable around the Pulley then pull upwards to the opening one rear of
Upper Frame. Repeat Procedure B to install a Pulley.
N.) Pull the Cable downwards between the two Guide Rods to the Selector Rod (#10).
Attach the string on the Weight Plate Selector Pin (#43) onto Selector Rod.
Securely thread the bolt at the end of the Cable into the Selector Rod. Use the
Weight Plate Selector Pin to select the numbers of weight plates to exercise.
O.) Connect the Lat Bar (#9) to the Cable with a Chain (#44) and two C-clips (#45).
Adjust the length of Chain for the desired Lat Bar exercises.
13