Connecting Your Tv; Back Connections; Connection Example; Connecting An Audio System - Digital Only - Toshiba 40CV550A Owner's Manual

Back connections

Connection example

Before connecting any external equipment, turn off all main
•
power switches.
The unauthorized recording of television programs, DVDs,
•
video tapes and other materials may infringe upon the
provisions of copyright law.
The COMPONENT VIDEO INPUT consists of three
•
component video signals (Y, P
best picture performance. These terminals can only be used
with the component video compatible equipment e.g. DVD
video player, etc.
Additional equipment and cables shown are not supplied
•
with this TV.
MONITOR OUTPUT
•
That will only support ATV/DTV signal to display out or by
VCR TV signal recording use.
If you connect mono sound equipment to MONITOR
•
OUTPUT, connect the audio input of the equipment to the
L/MONO jack on the TV.


Connecting your TV

/C , P /C
) and provides the
B B R R
Connecting an audio system
You can enjoy high quality dynamic sound by connecting the
TV to an audio system.
Notes:
DO NOT connect the DIGITAL AUDIO output terminal to
•
the AC-3 RF input of a Dolby Digital Receiver with a built-in

Dolby Digital decoder.

Connect the DIGITAL AUDIO output terminal to the Optical
•
or Coaxial input of a Receiver or Processor.
Refer to the owner's manual of the connected equipment as
•
well.
When you connect the TV to other equipment, be sure to turn
•
off the power and unplug all of the equipment from the wall
outlet before making any connections.
The output sound of the TV has a wide dynamic range. Be
•
sure to adjust the audio amplifier's volume to a moderate
listening level before turning on the power. Otherwise, the
speakers and your hearing may be damaged by a sudden
high volume sound.
Turn off the amplifier before you connect or disconnect the
•
TV's power cord. If you leave the amplifier power on, the
speakers may be damaged.
Warning:
When you are connecting (via the DIGITAL AUDIO output
terminal) an AV decoder that does not have Dolby Digital or
MPEG decoding function, be sure to set PCM in Digital Output
(page 27). Otherwise, the speakers and your hearing may
be damaged by a sudden high volume sound.

Connecting an amplifier equipped with a

Dolby Digital decoder
You can enjoy dynamic realistic sound by connecting the TV
to an amplifier equipped with a Dolby Digital decoder
or Dolby Digital processor. When using this setup, select
Bitstream in Digital Output menu.
- digital only -