Getting Started Switching On And Setting The Clock - Pioneer XR-A790 Operating Instructions Manual

4
OPEN/CLOSE
TAPE
TIMER/CLOCK ADJ
DISPLAY MODE
STANDBY/ON
OPEN/CLOSE
Function select buttons
Teclas de selección de función
24
En
TUNER/BAND AUX CD
DISPLAY
JOG
JOG
SET
23/8
Getting Started
Switching on and setting the
clock
You should now have your system installed with everything
connected up and plugged in. After switching on, the first thing to
do is to set the clock. This only needs to be done once (unless all
power to the unit is cut) and will enable you to use the timer
features.
Use the front panel controls to do this.
1 Press STANDBY/ON
• Pressing again switches the unit back into standby mode.
2 Press TIMER/CLOCK ADJ.
3 Turn the JOG dial until CLK ADJ (clock adjust) appears
in the display.
If this is the first time you've switched on the unit,
should already be displayed.
4 Press SET.
5 Turn the JOG dial to select 12 or 24 hour clock
format.
This setting affects the clock and timer setting displays. Choose the
format you prefer.
6 Press SET.
7 Use the JOG dial to set the hour.
8 Press SET.
9 Use the JOG dial to set the minute.
10 Press SET to finish.
• Press
DISPLAY MODE
anytime to show the current time. The display will revert to its
previous state after about five seconds.
Tip
There are a number of buttons other than
will switch the unit on. Pressing any of the function select buttons
( , / ,
CD TUNER BAND TAPE I
standby mode will turn the unit on and switch to that function.
Pressing the disc tray
OPEN
power on and select the CD function.
If you press with a disc loaded, the disc will also start playing.
CD
Likewise, if there is a tape loaded and you press
tape will begin playing.
Pressing 2 6 will switch on the power and start playing the
last selected function.
CLK ADJ
(front panel) or (remote)
DISPLAY
/
STANDBY ON
/ , ) when the unit is in
II AUX
/ button will also switch the
CLOSE
/ , the
TAPE I II
which