AXIS 210/211 - The I/O Terminal Block
44
Connect input/output devices to the terminal block as follows:
1. Loosen the corresponding screw on top of the pin (see above for the correct pin to
use).
2. Push the cable into the connector and secure it by fastening the screw.
3. Once devices are connected, connect the terminal block to the camera, making
sure that all cables are securely fastened.
Schematic Diagram - Terminal Connectors
3.3V
AXIS 210/211
Switch
camera
Mode
Power
Supply
GND
+
o
PS-K 9W
o
2
o
e.g. doorbell
1
Relay
o
3
o
4
o
o
o
o
Device
o o