to surpass reasonable sound levels. Before serious damage can be done, every loudspeaker will first
give a clear warning signal by means of severe audible distortion. That's the moment to lower the
volume. If the state of overloading (and severe audible distortion) will continue, serious damage to the
panels can occur. Because of the protection circuit's 'trade off' behavior, we do not guarantee that this
circuit will protect the loudspeaker against all possible kinds of mistreatment. Damage resulting from
such mistreatment is not covered by our warranty
conditions.
Where can I find more information about Final Sound?
For any questions about Final Sound or about installing your loudspeakers, contact your Final Sound
dealer or visit our website at www.finalsound.com.
8. Specifications 400i
Frequency response:
65Hz-22kHz +/- 3dB
Sensitivity: 86 dB (2.83 volts at 1 meter)
Impedance: nominal 4 ohm
Amplifier minimum: 50 Watt
Amplifier recommended: 75 Watt
Dimensions: 49.2 x 10.8 x 1.6 inch (125 x 27.5 x 4 cm)
Dimensions (electronics housing): 9.6 x 4.6 x 3.1 inch (24.5 x 11.6 x 8 cm)
Weight: 22lbs. (10.0kg)
Mounts: floor Stand (standard)
wall mount (additional cost)
Finish:
satin silver with black (standard)
FINAL SOUND 400i Loudspeaker Manual
vs. 1.4
-US-
c FS 2007RJ
24
.